NETGEAR DGFV338 ProSafe Reference Manual page 84

DGFV338 ProSafe Wireless ADSL Modem VPN Firewall Router Reference Manual
Table 0-1. Inbound Rules (continued)
Item Description
Schedule Select the desired time schedule (Schedule1, Schedule2, or Schedule3) that will be
used by this rule (see
• This drop down menu gets activated only when "BLOCK by schedule, otherwise
• Use schedule page to configure the time schedules.
Send to LAN Server This field appears only with NAT Routing (not Classical). This LAN address
determines which computer on your network is hosting this service rule. (You can
also translate this address to a port number.)
Translate to Port Check this box and enter a port number to assign the LAN Server to a different
Number service port number. Inbound traffic to the service port will have the destination port
number modified to the port number configured here.
WAN Destination IP Specifies the destination IP address applicable to incoming traffic.
Address This is the public IP address that will map to the internal LAN server; it can either be
the address of the ADSL or Ethernet WAN ports or another public IP address
WAN Users Specifies which Internet locations are covered by the rule, based on their IP
addresses. Select the desired option:
• Any – All Internet IP address are covered by this rule.
• Single address – Enter the required address in the start field.
• Address range – If this option is selected, you must enter the start and end fields.
LAN users This field appears only with Classical Routing (not NAT). Specifies which computers
on your network are affected by this rule. Select the desired options:
• Any – All PCs and devices on your LAN.
• Single address – Enter the required address and the rule will be applied to that
• Address range – If this option is selected, you must enter the start and finish fields.
• Groups – Select the Group to which this rule will apply. Use the LAN Groups screen
Log Specifies whether packets covered by this rule are logged. Select the desired action:
• Always – Always log traffic considered by this rule, whether it matches or not. This
• Never – Never log traffic considered by this rule, whether it matches or not.
Bandwidth Profile Specifies the name of a bandwidth limiting profile. Using a bandwidth profile,
bandwidth consumed by different connections can be limited. If multiple connections
correspond to the same firewall rule, they will share the same bandwidth limiting. See
"Configuring a Bandwidth Profile" on page
4-8
"Setting a Schedule for Firewall Rules" on page
Allow" or "ALLOW by schedule, otherwise Block" is selected as Action.
particular PC.
(under Network Configuration) to assign PCs to Groups. See
and Hosts" on page 7-4.
is useful when debugging your rules.
v1.0, May 2008
"Managing Groups
4-32.
Security and Firewall Protection
4-31).
.