NETGEAR DGFV338 ProSafe Reference Manual page 81

DGFV338 ProSafe Wireless ADSL Modem VPN Firewall Router Reference Manual
Table 4-1. Outbound Rules (continued)
Item Description
QoS Priority Specifies the priority of a service which, in turn, determines the quality of that service
for the traffic passing through the firewall. By default, the priority shown is that of the
selected service. The user can change it accordingly. If the user does not make a
selection (leaves it as Normal-Service), then the native priority of the service will be
applied to the policy. See
Log Specifies whether packets covered by this rule are logged. Select the desired action:
• Always – always log traffic considered by this rule, whether it matches or not. This
• Never – never log traffic considered by this rule, whether it matches or not.
Bandwidth Profile Specifies the name of a bandwidth limiting profile. Using a bandwidth profile,
bandwidth consumed by different connections can be limited. If multiple connections
correspond to the same firewall rule, they will share the same bandwidth limiting. See
"Configuring a Bandwidth Profile" on page
NAT IP Specifies whether the source IP address of the outgoing packets should be the WAN
interface address or a specified address, which should belong to the WAN subnet.
NAT single IP is on: Specifies to which WAN interface the NAT IP address belongs. All outgoing packets
will be routed through the specified WAN interface only.
To add a new Outbound Service:
1. Click the Add icon under the Outbound Services table. The Add LAN-WAN Outbound
Service screen will display.
Figure 4-2
2. Configure the Outbound Service fields for this policy (based on the field explanations above).
Security and Firewall Protection
"Setting Quality of Service (QoS) Priorities" on page
is useful when debugging your rules.
v1.0, May 2008
4-32.
4-18.
4-5