NETGEAR DGFV338 ProSafe Reference Manual page 113

DGFV338 ProSafe Wireless ADSL Modem VPN Firewall Router Reference Manual
3. From the System Logs section, check the boxes of the System Log events you want to track
and record:
• Change of Time by NTP: Logs a message when the system time changes after a request
to a Network Time server.
• Login Attempts: Logs a message when a login is attempted from the LAN network. Both
successful and failed login attempts will be logged.
• Secure Login Attempt: Logs a message when a login is attempted using the Secure
Remote Management URL. "Allow Remote Management" must be enabled (see the
Administration main menu and the Remote Management submenu). Both successful and
failed login attempts will be logged.
• Reboots: Records a message when the device has been rebooted through the Web
interface.
• All Unicast Traffic: All unicast packets directed to the router are logged.
• All Broadcast/Multicast Traffic: All broadcast or multicast packets directed to the router
are logged.
• WAN Status: Changes in WAN link status are logged.
• Resolved DNS Names: Successful DNS lookups are logged.
4. From the Other Event Logs section, check the boxes of the events you want to log:
• Source MAC Filter: Logs a message when a host is blocked by the source MAC filter.
• Session Limit: Logs a message when the session limit is applied to a host or group.
• Bandwidth Limit: Logs a message when the bandwidth limit is applied to a host or
group.
5. In the Enable E-Mail Logs section, select the Yes radio button if you want the logs e-mailed
(Enable E-Mail Logs is disabled by default). If you selected "Yes," fill in the following fields:
• E-mail Server address: Enter the IP address or Internet Name of an SMTP server. The
router will connect to this server to send the e-mail logs.
• Return E-mail Address: Type the e-mail address where the replies from the SMTP server
are to be sent; for example, failure messages.
• Send To E-mail Address: Type the e-mail address where the logs and alerts are to be sent.
• Authentication with SMTP server: If the SMTP server requires authentication before
accepting connections, select either Login Plain or CRAM-MD5 and enter the User
Name and Password to be used for authentication.
Security and Firewall Protection
v1.0, May 2008
4-37