Ack/Nak Mode; Communication Timeout; Nak Retries - Honeywell Voyager 1202G-BF User Manual

ACK/NAK Mode

ACK/NAK Mode On

Communication Timeout

This allows you to set the length (in milliseconds) for a timeout for the host ACK/NAK response. Scan the bar code below,
then set the timeout (from 0-65535 milliseconds) by scanning digits from the
Default = 2000 ms.
Timeout Retries
This setting limits the number of Communication Timeout retries. If the Timeout Retries is set to 0, the transmission is
terminated after the initial Communication Timeout. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the
0.
Communication Timeout Beeper
This selection programs the scanner to issue an error beep when a communication timeout has occurred. The error
beep sound is programmed using

NAK Retries

This selection limits the number of NAK retries that can occur in ACK/NAK mode. Scan the bar code below, then set the
number of retries (from 0-255) by scanning digits from the
mended setting.) Default = 0, or disabled.
2 - 6
Communication Timeout
Programming Chart, then scanning Save. (5 is the recommended setting.) Default =
Timeout Retries
Number of Beeps – Error
Programming
NAK Retries
Programming
(page 5-3). Default = On.
Chart, then scanning Save. (5 is the recom-
* ACK/NAK Mode Off
Chart, then scanning Save.
* On