Cisco Catalyst 2950 Hardware Installation Manual page 71

Chapter 2 Overview
Note
Figure 2-18 Bandwidth Utilization on Catalyst 2950-12 Switches
1x 2x 3x 4x 5x
SYST RPS
STAT UTIL DUPLX SPEED
MODE
0–0.0487%+
6.25–12.4%+
12.5–24%+
25–49%+
50%+
Figure 2-19 Bandwidth Utilization on Catalyst 2950-24, 2950C-24, 2950SX-24, and 2950T-24 Switches
1x 2x 3x 4x 5x 6x
SYST RPS
STAT UTIL DUPLX SPEED
MODE
0–0.0487%+
6.25–12.4%+
12.5–24%+
25–49%+
50%+
78-11157-05
For more information about GBIC LEDs, refer to your GBIC module
documentation.
Figure 2-18 to Figure 2-22
by the right-most LEDs.
The Catalyst 2950 LRE switch LEDs do not give utilization status.
If all LEDs on a Catalyst 2950-12, 2950-24, 2950C-24, 2950SX-24, or 2950T-24
switch are green (no amber showing), the switch is using 50 percent or more of
the total bandwidth. If the far-right LED is off, the switch is using more than 25
but less than 50 percent of the total bandwidth, and so on. If only the far-left LED
is green, the switch is using less than 0.0488 percent of the total bandwidth. (See
Figure 2-18 and Figure
10Base-T / 100Base-TX
6x 7x 8x 9x 10x 11x 12x
10Base-T / 100Base-TX
7x 8x 9x 10x 11x 12x 13x 14x
show the bandwidth utilization percentages displayed
2-19.)
15x 16x 17x 18x 19x 20x 21x 22x
Catalyst 2950 Desktop Switch Hardware Installation Guide
Front-Panel Description
Catalyst 2950
SERIES
Catalyst 2950
SERIES
100Base-FX
23x 24x 25x 26x
2-25