Connecting To A Patch Panel Or Pots Splitter - Cisco Catalyst 2950 Hardware Installation Manual

Chapter 3 Installation

Connecting to a Patch Panel or POTS Splitter

Step 1
Step 2
Step 3
78-11157-05
To connect the LRE port to a patch panel or POTS splitter, follow these steps:
Connect one end of a cable connected to the wiring trunk to the RJ-21 connector
(the LRE port) on the switch. (See
Referring to Figure 3-36
For a 90-degree connector, see the top of
•
For a 12-degree connector, see the bottom of
•
The cable tie is not included with the connector and cable assembly.
Note
Connect the other end of the cable to the patch panel or POTS splitter.
Figure 3-36
and Figure 3-37, secure the cable to the switch:
Catalyst 2950 Desktop Switch Hardware Installation Guide
Connecting to an LRE Port
and Figure 3-37.)
Figure 3-36 and Figure
Figure 3-36 and Figure
3-37.
3-37.
3-41