Cisco Catalyst 2950 Hardware Installation Manual page 166

Grounding the Switch
Step 4 Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire.
Figure C-2
Use the two number-10-32 screws to attach the ground lug and wire assembly to
Step 5
the rear panel of the Catalyst 2950G-24-EI-DC switch or to the front panel of the
Catalyst 2950ST-24 LRE 997 switch.
Using a ratcheting torque screwdriver, torque each ground-lug screw to 15 lbf-in.
Step 6
(240 ounce-force inches [ozf-in.]).
screws on a Catalyst 2950G-24-EI-DC switch.
Catalyst 2950 Desktop Switch Hardware Installation Guide
C-4
Crimping the Ground Lug
Appendix C
Figure C-3 shows how to torque the ground
Connecting to DC Power
78-11157-05