Connecting To An Ethernet Port - Cisco Catalyst 2950 Hardware Installation Manual

Connecting to an Ethernet Port

Connecting to an Ethernet Port
Step 1
Step 2
Catalyst 2950 Desktop Switch Hardware Installation Guide
1-10
Follow these steps to connect to an 10/100 or 10/100/1000 Ethernet port:
Connect a Category 5 straight-through cable (not supplied) to an 10/100 or
10/100/1000 port on a switch front panel. See
Connect the other end of the cable to the Ethernet (RJ-45) port of the workstation,
PC, server, or router.
For information about connecting to the GBIC module ports, see the
to GBIC Module Ports" section on page
For information about connecting to the SFP ports, see the
Module" section on page
Figure 1-3 Connecting to a Front-Panel Port
SYS T
1x
RPS 2x
3x
4x
STAT 5x
UTIL
DUP LX 6x
SPE ED
7x
8x 10B AS E-T
9x / 100 BA
MOD E
10x
11x
12x
13x
3
1
Catalyst 2950 switch
2 PC
3
Category 5 straight-through cable
3-44.
3-49.
SE -TX
14x
15x
16x
17x
18x Ca tal yst 29
19x
50
20x
SER IES
21x
22x
23x 100 BA SE
24x -FX
25
26
2
Chapter 1 Quick Installation
Figure 1-3.
"Connecting
"Connecting to an SFP
1
78-11157-05