Attaching The Rps Connector Cover - Cisco Catalyst 2950 Hardware Installation Manual

Installing the Switch on a Wall

Attaching the RPS Connector Cover

Warning
Catalyst 2950 Desktop Switch Hardware Installation Guide
3-24
Figure 3-18 Attaching Brackets for Wall-Mounting for the Catalyst 2950 Switch
If you are not using a redundant power system (RPS) with your switch, use two
number-4 Phillips pan-head screws to install an RPS connector cover to the back
of the switch. (See Figure
accessory kit.
If an RPS is not connected to the switch, install an RPS connector cover on the
back of the switch.
Figure 3-19 Attaching the RPS Connector Cover
RPS
connector cover
3-19.) The pan-head screws are included in the
RPS
connector
Chapter 3 Installation
Phillips
truss-head
screws
78-11157-05