Appendix; Connecting To Dc Power - Cisco Catalyst 2950 Hardware Installation Manual

Connecting to DC Power

To connect the Catalyst 2950G-24-EI-DC or Catalyst 2950ST-24 LRE 997 switch
to a direct current (DC)-input power source, follow these steps:
1.
2.
3.
Warning The Catalyst 2950G-24-EI-DC contains no field-replaceable units (FRUs). Do not
open the chassis or attempt to remove or replace any components. For
information about obtaining service for this unit, contact your reseller or Cisco
sales representative.
The Catalyst 2950ST-24 LRE 997 contains no field-replaceable units (FRUs). Do
Warning
not open the chassis or attempt to remove or replace any components. For
information about obtaining service for this unit, contact your reseller or Cisco
sales representative.
The equipment is to be installed in a restricted access area.
Warning
Warning Ethernet cables must be shielded when used in a central office environment.
78-11157-05
Preparing for Installation, page C-2
Grounding the Switch, page C-2
Wiring the DC-Input Power Source, page C-5
Catalyst 2950 Desktop Switch Hardware Installation Guide
A P P E N D I X
C
C-1