Cisco Catalyst 2950 Hardware Installation Manual page 111

Chapter 3 Installation
Step 3 Insert a dust plug into the optical ports of the SFP module to keep the optical
interfaces clean.
Step 4 Unlock and remove the SFP module, as shown in
Figure
•
Figure 3-28 Using the Mylar Tab Latch to Remove an SFP Module from a Slot
1 9 2 0
•
Figure 3-29 Using the Actuator Button Latch to Remove an SFP Module from an
1 9 2 0
•
78-11157-05
3-30.
If the module has a Mylar tab latch, pull the tab straight out so that you
remove the SFP module from the port in a parallel direction. Do not twist or
pull the tab because you could disconnect it from the SFP module.
2 1 2 2
2 3 2 4 C a ta ly s
t 2 9 5 0
L R E
SE R IE
S
1
1
If the module has an actuator button latch, use your thumb to push inward on
the wedge to free the locking pin, and use your index finger to grip the ridge
on top of the SFP module. Pull straight out to remove the module.
SFP Module Slot
2 1 2 2
2 3 2 4 C a ta ly s
t 2 9 5 0
L R E
SE R IE
S
1
1
If the module has a bale-clasp latch, pull the bale out and down to eject the
module. If the bale-clasp latch is obstructed and you cannot use your index
finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
Catalyst 2950 Desktop Switch Hardware Installation Guide
Installing and Removing SFP Modules
2
2
2
2
Figure 3-28, Figure 3-29, and
3-31