Where To Go Next - Cisco Catalyst 2950 Hardware Installation Manual

Where to Go Next

Step 1
Step 2
Step 3
Step 4
Step 5

Where to Go Next

Catalyst 2950 Desktop Switch Hardware Installation Guide
3-50
Follow these steps to connect a fiber-optic cable to an SFP module:
Remove the rubber plugs from the module port and fiber-optic cable, and store
them for future use.
Insert one end of the fiber-optic cable into the SFP module port (see
Figure 3-41 Connecting to an SFP Module Port
1 9 2 0
2 1 2 2
2 3 2 4
Cable
Insert the other cable end in a fiber-optic receptacle on a target device.
Observe the port status LED.
The LED turns green when the switch and the target device have an established
link.
The LED turns amber while the STP discovers the network topology and searches
for loops. This process takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable
problem, or there might be problem with the adapter installed in the target device.
See Chapter 3, "Troubleshooting,"
If necessary, reconfigure and restart the switch or target device.
For information about starting up the switch, see
For information about configuring the switch, refer to the switch software
configuration guide.
C a ta ly s
t 2 9 5 0
L R E
SE R IE
S
1
2
1
2
for solutions to cabling problems.
Chapter 3 Installation
Figure
Chapter 1, "Quick Installation."
78-11157-05
3-41).