Connecting To An Sfp Module - Cisco Catalyst 2950 Hardware Installation Manual

Chapter 3 Installation
Step 2
Step 3
Step 4

Connecting to an SFP Module

Caution
Note
78-11157-05
Insert the other cable end in a port on a target device.
Observe the port status LED.
The LED turns green when the switch and the target device have an established
link.
The LED turns amber while STP discovers the network topology and searches for
loops. This process takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable
problem, or there might be a problem with the adapter installed in the target
device. See Chapter 4, "Troubleshooting,"
Reconfigure and restart the switch or target device, if necessary.
This section describes how to connect to an SFP module. For instructions about
how to install or remove an SFP module, see the
Modules" section on page
Do not remove the rubber plugs from the SFP module port or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the SFP module ports and cables from contamination and ambient light.
Before connecting to an SFP module, be sure that you understand the port and
cabling stipulations in
section on page 2-14. See
about the LC on the SFP module.
Refer to the Catalyst 2950 LRE release notes for the list of supported SFP
modules.
for solutions to cabling problems.
3-28.
Table 2-2 on page 2-16
Appendix B, "Connectors and Cables,"
Catalyst 2950 Desktop Switch Hardware Installation Guide

Connecting to an SFP Module

"Installing and Removing SFP
and in the "SFP Module Slots"
for information
3-49