Cisco Catalyst 2950 Hardware Installation Manual page 38

Desktop switch
Hide thumbs Also See for Catalyst 2950:
Table of Contents

Advertisement

Entering the Initial Configuration Information
Step 8
Configure the interface by entering the switch IP address and subnet mask and
pressing Return. The IP address and subnet masks shown below are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Step 9
Enter Y to configure the switch as the cluster command switch. Enter N to
configure it as a member switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in the CMS. You can
configure the switch as a command switch later through the CLI or CMS interface.
To configure it later, type no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch, and the switch
displays that configuration. This is an example of the output that appears:
The following configuration command script was created:
hostname host_name
enable secret 5 $1$Max7$Qgr9eXBhtcBJw3KK7bc850
enable password my
line vty 0 15
password my_password
snmp-server community public
!
no ip routing
!
interface Vlan1
no shutdown
ip address 172.20.139.145 255.255.255.224
!
interface Vlan2
shutdown
no ip address
!
interface FastEthernet0/1
!
interface FastEthernet0/2
!
...<output abbreviated>
!!!
interface GigabitEthernet0/1
!
Catalyst 2950 Desktop Switch Hardware Installation Guide
1-8
Chapter 1
Quick Installation
78-11157-05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents