Show Mac Address-Table Multicast - Cisco Catalyst 2950 Command Reference Manual

show mac address-table multicast

show mac address-table multicast
Use the show mac address-table multicast user EXEC command to display the Layer 2 multicast
entries for the switch or for the VLAN.
Beginning with Release 12.1(11)EA1, the show mac address-table multicast command replaces the
Note
show mac-address-table multicast command (with the hyphen). The show mac-address-table
multicast command (with the hyphen) will become obsolete in a future release.
Syntax Description vlan vlan-id
count
igmp-snooping
user
| begin
| exclude
| include
expression
Defaults
This command has no default setting.
Command Modes
User EXEC
Command History Release
12.0(5.2)WC(1)
12.1(11)EA1
Usage Guidelines
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Catalyst 2950 Desktop Switch Command Reference
2-178
show mac address-table multicast [vlan vlan-id] [count] [igmp-snooping | user] [ | {begin |
exclude | include} expression]
(Optional) Specify a VLAN; valid values are 1 to 4094 when the enhanced
software image (EI) is installed and 1 to 1005 when the standard software
image (SI) is installed. Do not enter leading zeros. (This keyword is only
available in privileged EXEC mode.)
(Optional) Display total number of entries for the specified criteria instead
of the actual entries (only available in privileged EXEC mode).
(Optional) Display only entries learned through Internet Group
Management Protocol (IGMP) snooping (only available in privileged
EXEC mode).
(Optional) Display only the user-configured multicast entries (only
available in privileged EXEC mode).
(Optional) Display begins with the line that matches the specified
expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was first introduced.
The show mac-address-table multicast command was replaced by the
show mac address-table multicast command.
Chapter 2 Cisco IOS Commands
78-11381-05