Cluster Management-Vlan - Cisco Catalyst 2950 Command Reference Manual

cluster management-vlan

cluster management-vlan
Use the cluster management-vlan global configuration command on the command switch to change the
management VLAN for the entire cluster. Use the no form of this command to change the management
VLAN to VLAN 1.
Syntax Description
n
Defaults
The default management VLAN is VLAN 1.
Command Modes Global configuration
Command History Release
12.0(5.2)WC(1)
Usage Guidelines
Enter this command only on the command switch. This command changes the management VLAN of
the command switch and member switches. Member switches must have either a trunk connection or
connection to the new command-switch management VLAN to maintain communication with the
command switch.
This command is not written to the configuration file.
Examples
This example shows how to change the management VLAN to VLAN 5 on the entire cluster:
Switch(config)# cluster management-vlan 5
You can verify your settings by entering the show interfaces vlan vlan-id privileged EXEC command.
Related Commands Command
show interfaces
Catalyst 2950 Desktop Switch Command Reference
2-28
cluster management-vlan n
no cluster management-vlan
VLAN ID of the new management VLAN. Valid VLAN IDs are from 1 to 4094
when the enhanced software image (EI) is installed and 1 to 1001 when the
standard software image (SI) is installed. Do not enter leading zeros.
Modification
This command was first introduced.
Description
Displays the administrative and operational status of a switching
(nonrouting) port.
Chapter 2 Cisco IOS Commands
78-11381-05