Cisco Catalyst 2950 Command Reference Manual page 172

show dot1x
Authenticator State Machine
State
Reauth Count
Backend State Machine
State
Request Count
Identifier (Server) 2
Reauthentication State Machine
State
Table 2-5
Field
802.1X is enabled on GigabitEthernet0/2
Status
Port-control
Supplicant
Multiple Hosts
Current Identifier
1. This field and the remaining fields in the example show internal state information. For a detailed description of these state
machines and their settings, refer to the IEEE 802.1X standard.
This is an example of output from the show dot1x statistics interface gigiabitethernet0/1 command.
Table 2-6
Switch# show dot1x statistics interface gigabitethernet0/1
GigabitEthernet0/1
Rx: EAPOL
Tx: EAPOL
Catalyst 2950 Desktop Switch Command Reference
2-148
AUTHENTICATED
0
IDLE
0
INITIALIZE
show dot1x interface Field Description
1
describes the fields in the example.
EAPOL EAPOL
Start Logoff Invalid
0 0 0
Last Last
EAPOLVer EAPOLSrc
1 0002.4b29.2a03
EAP EAP
Total Req/Id Req/Oth
622 445 0
Description
Status of the port (authorized or unauthorized). The
status of a port appears as authorized if the dot1x
port-control interface configuration command is set to
auto, and authentication was successful.
Setting of the dot1x port-control interface
configuration command.
Ethernet MAC address of the client, if one exists. If the
switch has not discovered the client, this field displays
Not set.
Setting of the dot1x multiple-hosts interface
configuration command (allowed or disallowed).
Each exchange between the switch and the client
includes an identifier, which matches requests with
responses. This number is incremented with each
exchange and can be reset by the authentication server.
EAPOL EAP EAP
Total Resp/Id Resp/Oth
21 0 0
Chapter 2 Cisco IOS Commands
EAP
LenError
0
78-11381-05