Example: Adding The Static Address To The Mac Address Table; Example: Configuring Unicast Mac Address Filtering; Additional References For Device Administration; Feature History For Device Administration - Cisco Catalyst 9500 Manual

Example: Adding the Static Address to the MAC Address Table

Device(config)# mac address-table notification threshold limit 78
Example: Adding the Static Address to the MAC Address Table
This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a packet
is received in VLAN 4 with this MAC address as its destination address, the packet is forwarded to the specified
port:
Note You cannot associate the same static MAC address to multiple interfaces. If the command is executed again
with a different interface, the static MAC address is overwritten on the new interface.
Device(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface gigabitethernet1/1/1

Example: Configuring Unicast MAC Address Filtering

This example shows how to enable unicast MAC address filtering and how to configure drop packets that
have a source or destination address of c2f3.220a.12f4. When a packet is received in VLAN 4 with this MAC
address as its source or destination, the packet is dropped:
Device(config)# mac address-table static c2f3.220a.12f4 vlan 4 drop

Additional References for Device Administration

Related Documents
Related Topic
For complete syntax and usage information for the
commands used in this chapter.

Feature History for Device Administration

This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
40
Administering the Device
Document Title
Command Reference (Catalyst 9500 Series
Switches)