Pagp Port-Priority - Cisco Catalyst 2950 Command Reference Manual

pagp port-priority

pagp port-priority
You do not need to enter this command. It is documented for informational purposes only. Though
visible in the command-line help strings, the switch does not support the pagp port-priority command.
Use the pagp port-priority interface configuration command to select an interface through which all
Port Aggregation Protocol (PAgP) traffic through the EtherChannel is sent. Use the no form of this
command to return to the default value.
Syntax Description
priority
Defaults The default value is 128.
Command Modes
Interface configuration
Command History Release
12.1(6)EA2
Usage Guidelines
The pagp learn-method and the pagp port-priority interface configuration commands have no affect
on the switch hardware.
Note You should not change the port priority because the switch does not support this command.
Related Commands Command
pagp learn-method
show pagp
show running-config
Catalyst 2950 Desktop Switch Command Reference
2-114
pagp port-priority priority
no pagp port-priority
A priority number ranging from 0 to 255.
Modification
This command was first introduced.
Description
Sets the source-address learning method of incoming packets received from
an EtherChannel port.
Displays PAgP channel-group information.
Displays the configuration information running on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference for Release 12.1 > Cisco IOS File Management Commands >
Configuration File Commands.
Chapter 2 Cisco IOS Commands
78-11381-05