Before You Begin; Installing The Bracket - Cisco 6941 - Unified IP Phone Slimline VoIP Administration Manual

Before You Begin

Before You Begin
You will need these tools to install the bracket:
•
•
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does
not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a
regular telephone jack. For more information on phone installation requirements and warnings, see the
Setting Up the Cisco Unified IP Phone

Installing the Bracket

To install the phone on the wall, perform the following steps:
Procedure
Mount the wall bracket in the desired location
Step 1
jack, or you can run the Ethernet network cable to a jack nearby.
a.
b.
c.
d.
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
E-2
#1 and #2 Phillips-head screwdrivers
Level
Use the level to ensure the bracket is level, then use a pencil to mark the screw holes.
Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the
anchor into the wall.
Screw the anchor clockwise into the wall until it is seated flush.
Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.
chapter.
(Figure E-2). You can install the bracket over an Ethernet
Appendix
OL-23769-01