Honeywell MC ToolKit User Manual page 74

Messages and Diagnostic Codes
Memory Error
Message length is longer than
expected
Message length is shorter than
expected
Modem bad checksum
Modem Buffer overflow
Modem busy
Modem framing error
Modem illegal command
Modem illegal data
Modem network error
Modem Transmitter Serial Error!
No Response from the Transmitter
Resume Monitor Thread Failed!
Page 66
MC TOOLKIT/SDC 625 ERROR MESSAGES
If several programs are active, try closing one or more open programs.
Too many programs installed in the Pocket PC. Check the Pocket PC
free memory. Uninstall programs if need to release memory.
Too many data files in the Pocket PC. Check the Pocket PC free
memory. Delete unused data files to release memory.
Use the Pocket PC hardware reset. See your Pocket PC documentation
reset the unit. Caution for MCT101 Users: If the Symbol PPT 2800
computer is reset, it will lose all its installed programs and data. The
program will have to be installed again.
Communications problem between the Pocket PC computer and the
modem. Repeat the command again.
This could indicate a defective modem. Repeat the command again. If
the problem persist contact Honeywell TAC.
Communications problem between the Pocket PC computer and the
modem. Repeat the command again.
Make sure that the MC Toolkit field connections are connected to the
transmitter.
Verify the transmitter is wired correctly and that it is powered.
If connected to a DE transmitter, make sure the polarity of the cables
connecting to the transmitter is correct.
If connected to a HART transmitter, make sure the address number is
correct.
Make sure the correct protocol for the transmitter is selected.
A defective transmitter can also cause this error message.
Verify that a 250 ohm resistor in series with the transmitter.
Close all the other running applications.
Restart MC Toolkit application.
34-ST-25-20 MC Toolkit User Manual Release 3
9/06