Table 3 De Main Menu Procedures - Honeywell MC ToolKit User Manual

Procedural Considerations

Table 3 DE Main Menu Procedures

DE Main
Menu
Device
Info
General
Page 22
DE Main Menu Procedures
(ST 3000)
Tag ID (r/w)
User ID up to 8 alphanumeric characters (suggestion: relate
to functional process entities and/or plant areas).
Type (r)
Manufacturer's device type identifier (typically, a model
number)
Firmware Version (r)
Manufacturer's Firmware version identifier
Serial Number (r)
Manufacturer
Scratch Pad (r/w)
Up to 32 alphanumeric characters (suggestion: messages
to control room regarding observed/assigned operational
status)
(ST 3000)
34-ST-25-20 MC Toolkit User Manual
(STT 3000)
Note:
This message appears if the
<
the transmitter was set to
Output Mode (in Calibration
procedures), and the Output
was not later cleared.
(STT 3000) PV Type (r/w)
Communication Mode
(r/w) Select: Analog or DE
4 Byte or DE 6 Byte
FS Direction (r)
(Upscale or Downscale;
selection is jumpered in the
transmitter).
Line Filter (r)
Select: 50hz or 60hz.
T/C Fault Detect (r/w):
Select: Enabled or
Disabled.
button is selected if
Back
Select: Dual Range
(STDC) or Single Range or
Single Range w/SV
Release 3
9/06