Messages And Diagnostic Codes; Table 18 Mc Toolkit/Sdc 625 Error Messages - Honeywell MC ToolKit User Manual

Messages and Diagnostic Codes

Table 18 MC Toolkit/SDC 625 Error Messages

MESSAGE
Another Secondary master has been
detected! HART Protocol does not
support more than one secondary
master on the HART Network.
Checksum error on Modem Response!
Com Port Read Timeout!
Com read Error!
Error writing to Com Port!
Error writing to Com Port!
EscapeCom function Error!
GetCommState Error!
Host Failed to get good response from
the Modem!
Invalid Command number from the
Modem!
Invalid Handle Value!
Release 3
9/06
Messages and Diagnostic Codes
MC TOOLKIT/SDC 625 ERROR MESSAGES
Remove one of the secondary masters from the network.
A noisy environment can cause this error. Repeat the command again.
Ensure that the Honeywell supplied modem cable is used and that the
connections are secure.
Make sure the modem has a good battery.
Make sure ActiveSync is not running.
If several programs are active, try closing one or more open programs.
Stop the MC Toolkit application by doing File | Exit and restart the
program.
Use the Pocket PC hardware reset. See your Pocket PC documentation
reset the unit. Caution for MCT101 Users: If the Symbol PPT 2800
computer is reset, it will lose all its installed programs and data. The
program will have to be installed again.
MCT101 Users, make sure you are using a Honeywell approved Pocket
PC.
MCT101 Users: ensure that the Honeywell supplied modem cable is
used and that the connections are secure.
Make sure the modem has a good battery.
Communications problem between the Pocket PC and the modem.
Repeat the command again.
Make sure ActiveSync is not running.
If Several programs are active, try closing one or more open programs.
Stop the MC Toolkit application by doing File | Exit and restart the
program.
Use the Pocket PC hardware reset. See your Pocket PC documentation
reset the unit. Caution for MCT101 Users: If the Symbol PPT 2800
computer is reset, it will lose all its installed programs and data. The
program will have to be installed again.
Make sure you are using a Honeywell approved Pocket PC.
34-ST-25-20 MC Toolkit User Manual
Messages and Diagnostic Codes
CORRECTIVE ACTION
65