Enabling Peap - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Enabling Host-Based EAP

Enabling PEAP

Follow these steps to enable PEAP for this profile.
For EAP Type, select Cisco PEAP or PEAP. If you select Cisco PEAP, go to
Step 1
go to
Note
Tap the Properties button. The PEAP Properties screen appears (see
Step 2
Figure 5-10 PEAP Properties Screen
Make sure that the Validate server certificate check box is checked if server certificate validation is
Step 3
required (recommended).
If you want to specify the name of the server to connect to, check the Connect only if server name ends
Step 4
in check box and enter the appropriate server name suffix in the field below.
Note
Note
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
5-30
Step 8.
PEAP appears as an EAP Type option on a PPC 2002 device if the Microsoft PEAP
supplicant (rather than the Cisco PEAP supplicant) is installed.
If you enter a server name and the client adapter connects to a server that does not match the
name you entered, you are prompted to accept or cancel the connection during the authentication
process.
If you leave this field blank, the server name is not verified, and a connection is established as
long as the certificate is valid.
Chapter 5 Configuring the Client Adapter
Step 2. If you select PEAP,
Figure 5-10).
OL-1375-04