Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual page 61

Chapter 5 Configuring the Client Adapter
Table 5-2
Security Feature
EAP-TLS authentication
If using ACU to
configure card (on PPC
2002 devices)
If using Windows CE
.NET to configure card
(on PPC 2003 and
Windows CE .NET 4.2
devices)
PEAP authentication
If using ACU to
configure card (on PPC
2002 devices)
If using Windows CE
.NET to configure card
(on PPC 2003 and
Windows CE .NET 4.2
devices)
Fast roaming (CCKM)
Reporting access points
that fail LEAP or
EAP-FAST authentication
MIC
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
OL-1375-04
Client and Access Point Security Settings
Client Setting
Enable Host Based EAP and
Dynamic WEP Keys in ACU and
select TLS as the EAP Type in the
Authentication Manager
Select Enable 802.1X
Authentication on This Network
and TLS as the EAP Type
Enable Host Based EAP and
Dynamic WEP Keys in ACU and
select Cisco PEAP (or PEAP if the
Microsoft PEAP supplicant is
installed) as the EAP Type in the
Authentication Manager
Select Enable 802.1X
Authentication on This Network
and Cisco PEAP (or PEAP, which
denotes the Microsoft PEAP
supplicant) as the EAP Type
Enable LEAP or EAP-FAST and
use firmware version 5.40.10 or
later
No settings required; automatically
enabled in firmware version
5.40.10 or later
Automatically enabled in driver
Overview of Security Features
Access Point Setting
Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
Use firmware version 12.2(11)JA
or later, select a cipher suite that is
compatible with CCKM, and
enable Network-EAP and CCKM
for the SSID
Note To allow both 802.1X
clients and non-802.1X
clients to use the SSID,
enable optional CCKM.
No settings required; automatically
enabled in the following firmware
versions: 12.00T or later (340, 350,
and 1200 series access points) or
Cisco IOS Release 12.2(4)JA or
later (1100 series access points)
Set up and enable WEP with full
encryption, set MIC to MMH or
select Enable MIC check box, and
set Use Aironet Extensions to Yes
5-17