Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual page 51

Chapter 5 Configuring the Client Adapter
Table 5-1
Parameter
Transmit Power
Offline Channel Scan
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
OL-1375-04
Client Adapter Configuration Parameters (continued)
Description
Defines the power level at which your client adapter transmits. This
value must not be higher than that allowed by your country's regulatory
agency (FCC in the U.S., DOC in Canada, ETSI in Europe, MKK in
Japan, etc.).
Options: Max, 100 mW, 50 mW, 30 mW, 20 mW, 5 mW, or 1 mW
Default: Max (the maximum level programmed into the client adapter
Note
Note
Note
Note
Causes the client adapter to periodically scan for a better access point
with the same SSID if the signal strength falls below 50%.
Options: Enabled or Disabled
Default: Enabled
and allowed by your country's regulatory agency)
Reducing the transmit power level conserves battery power but
decreases radio range.
If the client adapter is running, ACU queries the adapter and
displays the settings programmed into the adapter. If the client
adapter is not running, ACU displays power level options based
on the last known radio type.
When World Mode is enabled, the client adapter is limited to
the maximum transmit power level allowed by the country of
operation's regulatory agency.
If you are using an older version of a 350 series client adapter,
your power level options may be different than those listed
here.
Configuring Your Client Adapter
5-7