Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual page 79

Chapter 6 Using EAP Authentication
Note
Obtain your LEAP or EAP-FAST username and password from your system administrator.
Step 2
Note
Enter your LEAP or EAP-FAST username in the User Name field.
Step 3
Enter your LEAP or EAP-FAST password in the Password field if your RADIUS server account was set
Step 4
up with a password.
Note
If your RADIUS server account specifies a domain, enter the domain name in the Domain field.
Step 5
Tap OK. If the username and password were entered correctly, they are written to volatile memory on
Step 6
the client adapter. The username and password remain on the client adapter until a different profile is
selected, the client adapter is ejected and reinserted, or the Windows CE device is reset.
Note
One of three scenarios occurs:
Step 7
The client adapter authenticates to the RADIUS server using your username and password and receives
1.
a dynamic, session-based WEP key. The ACU Profiles screen indicates if your client adapter is
authenticated to an access point.
If you enter the username or password incorrectly or enter ones that are not valid for the RADIUS
2.
server on the network, the Wireless Login Module screen reappears with a message indicating that
your login was incorrect. You are able to retry immediately by re-entering the username and
password.
The client adapter times out while trying to authenticate, possibly because it is out of range of an
3.
access point. After 30 seconds, a message appears indicating that the authentication attempt timed
out and that you need to rerun WLM.
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
OL-1375-04
You can also start WLM by selecting Start > Programs > Cisco > Wireless Login Module. You
may want to do this if you inadvertently exited WLM after it started or if you roam to a different
part of the network where a different login is required.
The password is optional because not all host accounts on the RADIUS server are set up with a
password.
For security reasons, the characters entered for the password are displayed as asterisks.
If you want to terminate the LEAP or EAP-FAST session, tap the Logout button. If you want to
exit WLM, tap the Cancel button.
Using LEAP or EAP-FAST
6-3