Using Peap; After Profile Selection, Card Insertion, Or Reset - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Using PEAP

Note
Step 6 Tap OK. The client adapter should now EAP authenticate.
To verify authentication on a PPC 2002 device, select Start > Programs > Cisco > AuthMgr. The Status
field at the bottom of the screen shows the authentication status. If the authentication is successful, the
Status field displays Authenticated, and the IP Address field displays the IP address of the client adapter.
Using PEAP

After Profile Selection, Card Insertion, or Reset

After you select a profile that uses host-based EAP authentication and configure the card for PEAP,
follow these steps to EAP authenticate.
These instructions are applicable for use with Windows NT or 2000 domain, LDAP, or OTP user
Note
databases after profile selection, card ejection and reinsertion, or reset.
If a message appears informing you that you need to select a certificate or other credentials to access the
Step 1
network, tap this message.
If a message appears indicating the root certification authority for the server's certificate and it is the
Step 2
correct certification authority, tap OK to accept the connection. Otherwise, tap Cancel.
If a message appears indicating the server to which your client adapter is connected and it is the correct
Step 3
server to connect to, tap OK to accept the connection. Otherwise, tap Cancel.
The Static Password screen appears (see
Step 4
Note
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
6-6
If your network uses a Cisco Secure ACS server, you must leave the Domain field blank and
enter the fully qualified domain name in the User Name field as follows:
username@fully.qualified.domain. For example, if your EAP-TLS username is jsmith and the
domain name is corporate on Cisco.com, you would enter jsmith@corporate.cisco.com in the
User Name field and leave the Domain field blank.
If a message appears prompting you to process your logon information for your wireless
network, tap this message. Then the Static Password screen appears.
Figure 6-4).
Chapter 6 Using EAP Authentication
OL-1375-04