Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual page 88

Viewing the Status of Your Client Adapter
Table 7-1
Table 7-1
Status
The first line of the Status screen
Signal Strength
Signal Quality
Noise Level
Overall Link Quality
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
7-4
interprets each element of the Status screen.
Client Adapter Status
Description
Indicates the operational mode of your client adapter and the
name or MAC address of any associated access point.
Value: Not Associated, Associated, Authenticated, or
Ad Hoc Mode
The access point name or MAC address is shown only if
Note
the client adapter is in infrastructure mode and Aironet
Extensions are enabled (on access points running Cisco
IOS release 12.2(4)JA or later).
The signal strength for all received packets. The higher the value
and the more green the bar graph is, the stronger the signal.
The histogram below the bar graph provides a visual
interpretation of the current signal strength. Differences in signal
strength are indicated by the following colors: green (strongest),
yellow (middle of the range), and red (weakest).
Range: 0 to 100% or –95 to –45 dBm
The signal quality for all received packets. The higher the value
and the more green the bar graph is, the clearer the signal.
The histogram below the bar graph provides a visual
interpretation of the current signal quality. Differences in signal
quality are indicated by the following colors: green (highest
quality), yellow (average), and red (lowest quality).
Range: 0 to 100%
Note This setting appears only if you selected signal strength to
be displayed as a percentage. See the
Strength Display Units" section on page 7-2
information.
The level of background radio frequency energy in the 2.4-GHz
band. The lower the value and the more green the bar graph is, the
less background noise present.
Range: –100 to –45 dBm
This setting appears only if you selected signal strength to
Note
be displayed in dBm. See the
Display Units" section on page 7-2
The client adapter's ability to communicate with the access point,
which is determined by the combined result of the adapter's
signal strength and signal quality.
Value: Not Associated, Poor, Fair, Good, Excellent
This setting appears only if you selected signal strength to
Note
be displayed as a percentage. See the
Strength Display Units" section on page 7-2
information.
Chapter 7 Performing Diagnostics
"Setting Signal
for
"Setting Signal Strength
for information.
"Setting Signal
for
OL-1375-04