Cisco ATA186-I2 Administrator's Manual page 123

Chapter 5 Parameters and Defaults
Table 5-7
Component
NumOfRepeats
TotalToneTime
ReorderTone Parameter Example 2
Assume that you want a reorder tone in which:
The only frequency is 400 Hz.
•
The frequency plays six times, each time for 0.1 second followed by 0.9 second of silence.
•
The frequency then plays once for 0.3 second followed by 0.7 second of silence.
•
The volume of the frequency is –19 dBm.
•
The tone plays until another call event stops the tone.
•
For this reorder tone, make the following setting. See
ReorderTone:100,1,31164,1620,0,0,0,0,2,800,7200,2400,5600, 0,0,5,0
Table 5-8
Component
Sequential
NumOfFreqs
TFreq1
TAmp1
TFreq2
TAmp2
TFreq3
TAmp3
NumOfOnOffPairs
OnTime1
OffTime1
OnTime2
OffTime2
OnTime3
OffTime3
OL-4804-01
Reorder Tone Parameter Example 1 Explanation (continued)
Setting
0
0
Reorder Tone Parameter Example 2 Explanation
Setting
100
1
31164
1620
0
0
0
0
2
800
7200
2400
5600
0
0
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
Explanation
First on-off pair of the cadence plays once
(does not repeat), then the second on-off pair
plays
Tone plays continuously (set of three on-off
pairs of the cadence repeat continuously) until
another call event stops the tone
Table 5-8
Explanation
Required setting for a tone with one frequency
One frequency in the tone
First frequency is 400 Hz
First frequency volume is –19 dBm
No second frequency
No second frequency
No third frequency
No third frequency
Two on-off pairs in the cadence of the tone
Sound in first on-off pair plays for 0.1 second
Sound in first on-off pair is followed by 0.9
second of silence
Sound in second on-off pair plays for 0.3
seconds
Sound in second on-off pair is followed by 0.7
second of silence
No third on-off pair in the cadence
No third on-off pair in the cadence
Tone Configuration Parameters
for a detailed explanation.
5-47