Additional H.323 Services
Related Parameter
ConnectMode, page 5-32
Configuring Network Ringback Tone
You can configure the Cisco ATA to send a ringback tone to a caller by using bit 19 of the ConnectMode
parameter.
Related Configuration Parameter
ConnectMode, page 5-32
Configuring Reverse Audio Cut-Through Behavior
You can configure the reverse audio cut-through behavior of the Cisco ATA by using Bit 5 of the
ConnectMode parameter.
Related Configuration Parameter
ConnectMode, page 5-32
Configuring Supplementary Service Behavior and Parameters
Service providers can offer many supplementary services, which can be activated, configured, or
deactivated in more than one way.
The behavior and activation/deactivation of call supplementary services can be different from one
country to another. You can use the CallCmd parameter to define the behavior and the
activation/deactivation access code for the supplementary services that the Cisco ATA supports.
Related Configuration Parameter
CallCmd, page 5-29
Debugging Diagnostics
You can use the following parameter to troubleshoot operation issues:
•
Hardware Information Display
Cisco ATA hardware information is displayed in the lower-left corner of the Cisco ATA Web
configuration page.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
4-10
NPrintf, page
5-61—Use this parameter to specify the IP address and port where debug information
is sent.
Chapter 4
Basic and Additional H.323 Services
OL-4804-01