Table of Contents
Advertisement
Tone Configuration Parameters
Table 5-8
Component
NumOfRepeats
TotalToneTime
Recommended Values
The following settings are recommended for the US:
•
•
•
•
•
•
For detailed recommendations of tone-parameter values by country, see
Note
Cisco ATA Tone Parameter Values by Country."
Specific Tone Parameter Information
Brief descriptions, and lists of default values and the voice configuration menu code for each Cisco ATA
tone parameter, appear in the following sections:
•
•
•
•
•
•
DialTone
Description
The Cisco ATA plays the dial tone when it is ready to accept the first digit of a remote address to make
an outgoing call.
Default values (using the Basic format)
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
5-48
Reorder Tone Parameter Example 2 Explanation (continued)
Setting
5
0
DialTone = "2,31538,30831,1380,1740,1,0,0,1000" (approximately -17 dBm)
BusyTone = "2,30467,28959,1191,1513,0,4000,4000,0" (approximately -21 dBm)
ReorderTone = "2,30467,28959,1191,1513,0,2000,2000,0" (approximately -21 dBm)
RingBackTone = "2,30831,30467,1943,2111,0,16000,32000,0" (approximately -16 dBm)
CallWaitTone = "1,30831,0,5493,0,0,2400,2400,4800" (approximately -10 dBm)
AlertTone = "1,30467,0,5970,0,0,480,480,1920"
DialTone, page 5-48
BusyTone, page 5-49
ReorderTone, page 5-49
RingbackTone, page 5-50
CallWaitTone, page 5-50
AlertTone, page 5-51
NumOfFreqs—2
Explanation
First on-off pair of the cadence plays six times
(plays once and then repeats five times), then
the second on-off pair plays
Tone plays continuously (set of two on-off
pairs of the cadence repeat continuously) until
another call event stops the tone
Chapter 5
Parameters and Defaults
Appendix E, "Recommended
OL-4804-01
Advertisement
Table of Contents
