Table of Contents
Advertisement
Parameters and Defaults
This section provides information on the parameters and defaults that you can use to create your own
Cisco ATA configuration file. This section also includes the voice configuration menu code for each
parameter that has such a code.
Parameters are divided into categories based on their functionality. The following categories of
parameters are covered in this section:
User Interface (UI) Security Parameter, page 5-3
•
•
Parameters for Configuration Method and Encryption, page 5-4
Network Configuration Parameters, page 5-8
•
H.323 Parameters, page 5-13
•
Audio Configuration Parameters, page 5-21
•
•
Operational Parameters, page 5-26
Telephone Configuration Parameters, page 5-37
•
•
Tone Configuration Parameters, page 5-41
Dial Plan Parameters, page 5-52
•
Diagnostic Parameters, page 5-60
•
CFGID—Version Parameter for Cisco ATA Configuration File, page 5-63
•
The following list contains general configuration information:
Your configuration file must begin with #txt.
•
The Cisco ATA uses the following parameter types:
•
–
–
–
–
OL-4804-01
Alphanumeric string
Array of short integers
Boolean (1 or 0)
Bitmap value—unsigned hexadecimal integer (for specifying bits in a 32-bit integer)
Bits are numbered from right to left, starting with bit 0.
Note
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
C H A P T E R
5
5-1
Advertisement
Table of Contents
