Cisco ATA186-I2 Administrator's Manual page 122

Tone Configuration Parameters
Two examples of Extended Format B, both using the Reorder tone, follow.
ReorderTone Parameter Example1
Assume that you want a reorder tone in which:
The frequencies 900 Hz, 1400 Hz, and 1800 Hz play sequentially.
•
Each frequency plays once for 0.33 seconds.
•
There is no silence after the first and the second frequencies.
•
There is 1 second of silence after the third frequency (before the first frequency starts again)
•
The volume of each frequency is –19 dBm.
•
The tone plays until another call event stops the tone.
•
For this reorder tone, make the following setting. See
ReorderTone:101,3,24917,3405,14876,4671,5126,5178,3,2640,0,2640,0,
2640,8000,0,0
Table 5-7
Component
Sequential
NumOfFreqs
TFreq1
TAmpl1
TFreq2
TAmp2
TFreq3
TAmp3
NumOfOnOffPairs
OnTime1
OffTime
OnTime2
OffTime2
OnTime3
OffTime3
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
5-46
Reorder Tone Parameter Example 1 Explanation
Setting Explanation
101 Frequencies play sequentially
3 Three frequencies in the tone
24917 First frequency is 900 Hz
3405 First frequency volume is –19 dBm
14876 Second frequency is 1400 Hz
4671 Second frequency volume is –19 dBm
5126 Third frequency is 1800 Hz
5178 Third frequency volume is –19 dBm
3 Three on-off pairs in the cadence of the tone
2640 Sound in first on-off pair plays for 0.33
seconds
0 No silence after the first sound (the second
sound plays immediately)
2640 Sound in second on-off pair plays for 0.33
seconds
0 No silence after the second sound (the third
sound plays immediately)
2640 Sound in third on-off pair plays for 0.33
seconds
8000 1 second of silence after the sound in the third
on-off pair (before the pattern repeats,
beginning with the first on-off pair)
Chapter 5
Table 5-7 for a detailed explanation.
Parameters and Defaults
OL-4804-01