Complete Reference Table of all Cisco ATA H.323 Services
Selecting H.323 Connection and H.245 Transmission Methods
You can configure the H.323 connection method and the H.245 transmission method. Use Bit 0 of the
ConnectMode parameter to select either the slow-start procedure or the fast-start procedure for the H.323
connection. Use Bit 1 of the ConnectMode parameter to select either a separate H.245 connection or
H.245 tunneling for H.245-message transmission.
Related Configuration Parameter
ConnectMode, page
Setting Dial Plans
You can set specific dial plan rules and timeout values. Many of these values are determined on a
country-by-country basis.
Related Parameter
DialPlan, page 5-52
Complete Reference Table of all Cisco ATA H.323 Services
Table 4-4
includes links to the detailed descriptions of the parameters used for configuring these features.
Table 4-4
Configurable Features
Audio Media Features
•
•
•
•
•
Audio cut-through configuration
Caller ID format
DTMF and hookflash transmission methods
Debug and Diagnosis
Dial plans
Fax Services Features
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
4-12
5-32—Bits 0 and 1
is a reference table that lists all configurable features for the Cisco ATA (using H.323), and
Configurable Features and Related Parameters
Low bit-rate codec selection (G.723.1, G.729)
Silence suppression
RTP media port
Preferred audio codec for transmitting and
receiving voice data
RTP packet size
Fax services mode selection
Named Signaling Event (NSE) payload type for
fax pass-through
Chapter 4
Basic and Additional H.323 Services
Related Parameters
Audio Media Parameters
LBRCodec, page 5-23
•
•
AudioMode, page 5-24
•
MediaPort, page 5-21
•
TxCodec, page
5-22,
RxCodec, page 5-22
•
NumTxFrames, page 5-25
ConnectMode, page 5-32
CallerIdMethod, page 5-38
AudioMode, page 5-24
NPrintf, page 5-61
DialPlan, page 5-52
Fax Services Parameters
AudioMode, page
5-24,
•
page 5-32
ConnectMode, page 5-32
•
ConnectMode,
OL-4804-01