Chapter 4
Deploying the C65/76M
Deployment and Commissioning Process
There are three methods that can be used to enable CEMF to monitor a Catalyst 6000 family switch or
a Cisco 7600 series Internet Router:
•
•
•
The remaining C65/76M objects are automatically discovered when the Network Element object is
commissioned.
IP Auto Discovery
The CEMF Auto Discovery application is used to search an existing network. The network is examined
for IP and SNMP devices. An object is created for each new device discovered. The IP discovery window
can be launched from either the Discovery icon from the CEMF Launchpad
Deployment/Auto Discovery... pop-up menu item on a selected object as shown in
IP Auto Discovery
This method should be used to deploy a large number of devices that are currently connected to the
network. This method automatically deploys the Network Element and Software objects for each
Catalyst 6000 family switch or Cisco 7600 series Internet Router discovered.
Manual deployment
This method should be used if a small number of devices that are connected to the network need to
be deployed. This method will deploy the Network Element and Software objects for the Catalyst
6000 family switches or Cisco 7600 series Internet Routers specified.
Predeployment
This method should be used to predeploy a device that is not connected to the network. The
following objects can be predeployed:
–
Network Element and Software
–
Chassis
Supervisor Modules
–
Ethernet Modules
–
Switch Fabric Modules
–
FlexWAN Modules
–
–
Port Adapters
–
OSM Modules
Deployment and Commissioning Process
(Figure
Cisco 6500/7600 Series Manager User Guide
3-2) or from the
Figure
4-2.
4-5