Routing Protocol Tab - Cisco VS-C6509E-S720-10G User Manual

C6576M ATM E3 Interface Dialog Box

Routing Protocol Tab

Figure 5-50
Figure 5-50 Routing Protocol Tab of the C6576M ATM E3 Interface Dialog Box
OSPF Area
The OSPF area contains the following information:
•
•
•
•
Cisco 6500/7600 Series Manager User Guide
5-98
shows the Routing Protocol tab of the C6576M ATM E3 Interface dialog box.
OSPF Network Type—OSPF network type. ATM is a point-to-point service; by default it is
considered to be nonbroadcast by the OSPF routing process. An ATM interface can, however, be
configured as a broadcast interface. The OSPF network type can also be dependent on the ATM
network configuration, whether the network is partially meshed or fully meshed.
Area ID—The predefined ID uniquely identifying the area to which the interface connects. It can be
specified as either a decimal value or as an IP address. Value is 0.0.0.0 if interface is a layer 2 (no
IP address assigned) interface. This attribute is read-only.
Authentication Key—Password to be used by neighboring OSPF routers on a network segment that
is using OSPF simple password authentication. This password is ignored if OSPF Authentication
Type is not "simple". This attribute is read-only.
Hello Interval—Length of time between the hello packets sent on an OSPF interface. Must be
consistent among all routers on an attached network. This attribute is read-only.
Chapter 5 Physical Object Dialog Boxes