Routing Protocol Tab - Cisco VS-C6509E-S720-10G User Manual

C6576M OSM Serial Subinterface Dialog Box

Routing Protocol Tab

Figure 5-83
Figure 5-83 Routing Protocol Tab on the C6576M OSM Serial Subinterface Dialog Box
OSPF Area
The OSPF area of the C6576M OSM POS Interface dialog box provides the following information. All
the attributes in this area are read-only.
•
•
•
•
Cisco 6500/7600 Series Manager User Guide
5-160
shows the Routing Protocol tab of the C6576M OSM Serial Subinterface dialog box.
Network Type—OSPF interface type. By default, a POS interface is point-to-point, however, the
OSPF network type may be modified to accommodate different types of network configurations.
This attribute has one of the following values:
broadcast
–
nbma
–
pointToPoint
–
pointToMultipoint
–
Area ID—The predefined ID uniquely identifying the area to which the interface connects. It can be
specified as either a decimal value or as an IP address. Value is 0.0.0.0 if the interface is a Layer 2
(no IP address assigned) interface. This attribute is read-only.
Authentication Key—Password to be used by neighboring OSPF routers on a network segment that
is using OSPF simple password authentication. Ignored if Authentication Type is not "simple".
Hello Interval (sec)—Frequency at which the device will send hello packets on the specified
interface and EIGRP autonomous system number.
Chapter 5 Physical Object Dialog Boxes