Cisco VS-C6509E-S720-10G User Manual page 221

Chapter 5 Physical Object Dialog Boxes
•
•
•
SONET Medium Configuration Area
The SONET Medium Configuration area contains the following information. All attributes in this area
are read-only.
•
•
•
NSAP Address—Unique identifier of node in ATM network. Required if not implemented by ATM
CM.
End-Station ID—End-station ID of node in ATM network. The NSAP address prefix is provided by
the switch to the router through ILMI. There must be a PVC configured for ILMI communication
with the switch. Required if not implemented by ATM CM.
SONET Path Width—Width of the SONET path. This attribute is read-only. This is described by
the STS-Nc SPE.
STS-3c/STM-1—For OC-3 signal (155.52 Mbps).
–
STS-12c/STM-4—For OC-12 signal (622.08 Mbps).
–
Type—Indicates whether or not a SONET or SDH signal is used on the interface.
Line Type—Line type of the interface. The following values are possible:
– sonetShortSingleMode
sonetLongSingleMode
–
sonetMultiMode
–
Line Coding—Line coding for the interface:
sonetMediumB3ZS—For electrical SONET/SDH signals (STS-1 and STS-3).
–
– sonetMediumCMI—For electrical SONET/SDH signals (STS-1 and STS-3).
– sonetMediumNRZ—Non-return to Zero, which is used for optical SONET/SDH signals.
– sonetMediumRZ—Return to Zero, which is used for optical SONET/SDH signals.
– sonetMediumOther—Other.
C6576M ATM SONET Interface Dialog Box
Cisco 6500/7600 Series Manager User Guide
5-107