Performance Tab - Cisco VS-C6509E-S720-10G User Manual

C6576M OSM GE-WAN Interface Dialog Box
Note The Delay attribute is an informational parameter used only to communicate the current bandwidth to
the higher-level protocols (such as IGRP and EIGRP); you cannot adjust the actual delay of an interface
with this command.
•
Note The Bandwidth attribute is an informational parameter used only to communicate the current bandwidth
to the higher-level protocols (such as IGRP, EIGRP, and OSPF); you cannot adjust the actual bandwidth
of an interface with this command.
Layer 2 Area
The Layer 2 area of the C6576M OSM GE-WAN interface dialog box provides the following
information:
•
•
Note A GE interface that is using a nondefault MTU cannot be added to an EtherChannel with GE interfaces
using the default MTU. If the interface MTU is changed for one interface, the change is applied to all
interfaces (GE and GE EtherChannel) using a nondefault MTU.
Note IOS 12.1(8a)E5 caveat: Jumbo frame support is incompatible with the IS-IS routing protocol. Leave the
MTU size at the default value on any interface where IS-IS provides routing.
Layer 3 Area
The Layer 3 area of the C6576M Ethernet Interface dialog box provides the following information:
•
•
•

Performance Tab

Figure 5-60
attributes in this area are read-only.
Cisco 6500/7600 Series Manager User Guide
5-118
Bandwidth—Overwrites default bandwidth in kilobits per second.
MAC Address—Displays the MAC address of the interface.
MTU—The size, specified in octets, of the largest datagram (frame) that can be sent on the interface.
IP Address—Displays the IP address of the layer 3 interface.
Netmask—Subnet mask of the interface IP address. Enabled bits indicate the network addressing
bits in the IP address.
Clear IP Address button—After receiving confirmation, will unset the IP address for this interface.
shows the Performance tab of the C6576M OSM GE-WAN Interface dialog box. All
Chapter 5 Physical Object Dialog Boxes