Configuration Summary - Cisco Prisma II 1550 nm Installation And Operation Manual

Configuration Summary

You can use any of the methods listed above to perform the following configuration
tasks:
Enable or disable transmitter operation

Enable or disable the "RF input low" alarm

Configure the module as master or slave

Set the relative RF drive level into the transmitter

Return to the factory default settings (except LCI)

Turns automatic gain control (AGC) on or off

For detailed information on configuring this module, refer to Operation using ICIM
(on page 37) or Operation using LCI (on page 73).
78-4019959-01 Rev D
Module Configuration
11