To Restart The Icim By Removing The Icim - Cisco Prisma II 1550 nm Installation And Operation Manual

3 Press the
4 Use the
5 Press the
Use the
6
parameter; IP Address, IP Subnet, or Gateway IP.
7 Press the
the first segment of the address is highlighted.
Enter the correct numbers for the first segment of the address.
8
Note: One of two methods can be used to enter the numbers, as follows:

Press the
 Press the
Numlock On appears on the front panel LCD. Then enter the exact number
using the number keys on the 12-key numeric keypad.
Press the
9
to the right. You can also use the
segment of your choice.
Note: If you are using the numeric entry mode, the cursor moves to the next
address segment to the right automatically after you enter the last digit of the
current address segment.
10 Repeat steps 8 and 9 until all address segments are entered. After you enter the
last address segment and press the Enter key, the system returns to the IP Setup
menu.
11 Repeat steps 6 through 10 for each IP Setup parameter that you need to enter.
12 Restart the ICIM.
Important: IP Setup parameters do not take effect until the ICIM is restarted.

To Restart the ICIM by Removing the ICIM

Unscrew the captive screw near the top right-hand corner of the ICIM.
1
2 Unlock the top and bottom ejector levers near the left-hand side of the ICIM.
3 Pull the ejector levers out and away from the front panel to disconnect the ICIM
from the chassis backplane connector.
4 Pull the ICIM at least 1.5 inches (3.81 cm) out from the front of the chassis to
ensure that it is fully separated from the chassis backplane connector.
Reinsert the ICIM into the chassis until the ejector levers insert into their
5
respective slots in the chassis.
Push the ejector levers in and flat against the ICIM front panel to reconnect the
6
ICIM to the backplane connector until the ejector levers lock in place.
Screw in the captive screw to secure the ICIM in the chassis.
7
78-4019959-01 Rev D
ICIM
key. The ICIM menu appears.

key to scroll down until IP Setup is highlighted.
SEL
key. The IP Setup menu appears.
 
or keys to scroll to and highlight the desired configuration
SEL
key. The Adjust menu for the selected IP parameter appears, and

or keys to increase/decrease the number to set value.
SHIFT
key to change to the numeric entry mode. Confirm that
ENTER
key to accept your entry and move to the next address segment
 
or keys to move to the address
SNMP Configuration
63