Cisco Prisma II 1550 nm Installation And Operation Manual page 139

Q
QAM • 111
R
Rear-Access Chassis - Front Panel Illustration •
17
Recommended Equipment • 26
Redundancy Interface Panel • 35
RF • 111
RMA • 111
RT • 112
RX • 112
S
Saving the Configuration using the ICIM • 61
SBS • 112
Setting SNMP Trap Receiver Parameters • 65
Site Requirements • 15
SMC • 112
SNMP • 112
SNMP Configuration • 62
SNMP Considerations • 62
Space Requirements • 15
Starting LCI Software • 81
STATUS Menus • 53
Support Telephone Numbers • 100
System Requirements • 75
T
Table of Inserted Modules • 66
Table of Removed Modules • 66
TEC • 112
Tips for Optimal Fiber Optic Connector
Performance • 26
TNCS • 112
To Access the ICIM LCD Contrast • 49
To Access the Password Menu • 44, 45, 46
To Adjust Alarm Thresholds • 71
To Change Parameters • 70
To Change the User Password • 46
To Check Alarms using ICIM • 56
To Check Alarms using LCI • 89
To Check Manufacturing Data • 59
To Check Manufacturing Data using LCI • 93
To Check the Operating Status using ICIM • 53
To Check the Operating Status using LCI • 86
To Clean Optical Connectors • 27
To Configure Parameters using LCI • 87
To Configure Parameters using the ICIM • 54
78-4019959-01 Rev D
To Connect a Computer to the Chassis • 79
To Connect Chassis-to-Chassis ICIM IN and
ICIM OUT Ports • 30
To Connect Optical Cables to Module • 28
To Connect RF Cables for Each Module • 19
To Connect TNCS to the Chassis EM IN Port •
31
To Disable the User Password using ICIM • 47
To Enter the User Password • 44, 45
To Install the Host Module in the Chassis • 22
To Install the LCI Software • 76
To Install the Module in a Prisma II XD Chassis
• 23
To Install the Transmitter Modules in the Host
Module • 21
To Modify Alarm Limits using LCI • 91
To Prepare to Change Parameters • 69
To Pull the Optical Cable to the Module • 25
To Restart the ICIM by Removing the ICIM • 63
To Restart the ICIM using ICIM • 70
To Save the Current Configuration • 61
To Set Adjustable Alarm Thresholds using the
ICIM • 57
To Set Traps for a Specific IP Address using
P2TrapRecvEntry • 65
To Set Up the IP Configuration Parameters for
SNMP Support using ICIM • 62
To Start LCI Software • 81
torque • 112
Troubleshooting • 97
Troubleshooting Alarm Conditions • 97, 98
TX • 112
U
Unpacking and Inspecting the Module • 14
Using the ICIM • 49
Using TNCS with Multiple Chassis • 32
Index
115