Alarms Menus; To Set Adjustable Alarm Thresholds Using The Icim - Cisco Prisma II 1550 nm Installation And Operation Manual

ALARMS Menus

When a module ALARMS menu is selected, press the
scroll through alarms. Some typical ALARMS menus are shown below.
A L A R M S
S h e l f
S l o t
H D T x Q
I n R F
M i n L
Note: For details on all alarm parameters, see Module Parameter Descriptions (on
page 101).

To Set Adjustable Alarm Thresholds using the ICIM

You can use the ICIM to change the adjustable alarm thresholds of this module from
their factory default values.
1 At the MODULE menu, press the
ICIM LCD.
2 Press the
label n/a is displayed, you cannot configure that alarm threshold. Press the
key to highlight the alarm threshold for the next parameter.
3 When the threshold that you wish to set is highlighted, press the
Press the
4
5 Press the
Note: Press the Cancel (
Press the
6
ICIM LCD.
When finished, press the
7
78-4019959-01 Rev D
A L A R M S
S h e l f 5
5
S l o t 1 6
1 6
H D T x Q
O u t P w r
M i n H
SEL
key. The alarm thresholds previously set are displayed. If the

key or the

key or the
ALRM
ENTER
key to save the changes. The message Data Saved appears on the
MAIN
A L A R M S
S h e l f
S h e l f 5
S l o t
S l o t 1 6
H D T x Q
L a s B i a s
M a j L
key. The STATUS menu appears on the
STAT

key to change the increment size.
key to adjust the alarm threshold.
) key to return to the previous menu.
key to return to the MAIN menu.
Checking Module Alarms using the ICIM

key or the
A L A R M S
5
1 6
H D T x Q
L a s T e m p
M a j H
TP347
ENTER

key to

key.
57