To Connect Optical Cables To Module - Cisco Prisma II 1550 nm Installation And Operation Manual

Chapter 2 Module Installation

To Connect Optical Cables to Module

Note: This procedure assumes that the chassis is mounted in a rack.
Important: Observe laser safety precautions. Refer to the Laser Safety information
earlier in this guide.
Complete the following steps for each optical cable to be connected to the module.
Attach one end of the optical cable to the optical output connector located on the
1
front of the module.
2 Route the other end of the optical cable to the appropriate destination.
28 78-4019959-01 Rev D