High Density Superqam Transmitter Parameters; Operating Status Parameters - Cisco Prisma II 1550 nm Installation And Operation Manual

High Density SuperQAM Transmitter Parameters

Operating Status Parameters

Parameter
Name (LCI)
Optical Output
Power
Laser Bias
Current
RF Input
Power
Module
Temperature
TEC Current
Laser
Temperature
Laser RF Drive
ITU
Laser Enable
Low RF Alarm
Inhibit
Master
RF Drive Level
AGC
Length
Dither
Note: Monitored values may vary from module to module. The values shown above
are examples only.
78-4019959-01 Rev D
ICIM Function
Abbreviation
OutPwr Displays optical output power.
LasBias Displays laser bias current.
InRF Displays RF input level.
ModTemp Displays module temperature.
TecCur Displays laser thermoelectric cooler
current.
LasTemp Displays laser temperature.
LasRF RF drive level at laser input reference to
nominal setup.
ITU Displays transmitter ITU channel.
Enable Laser on/off.
LoRFInh Low RF alarm enabled/disabled.
Master Master or Slave operation.
RFDrive RF drive level reference to nominal
setup.
AGC Automatic Gain Control.
FibLinDi Displays distance setting in kilometers.
Dither Displays dither On/Off (usually Off).
High Density SuperQAM Transmitter Parameters
Typical
Value
10.1 dBm
88 mA
0.0 dB
28.5 °C
112.9 mA
19.0 °C
-1.5 dB
20-59
-
-
-
0.0
-
50 km
-
105