Connecting The Rf Cables To The Chassis; To Connect Rf Cables For Each Module - Cisco Prisma II 1550 nm Installation And Operation Manual

Connecting the RF Cables to the Chassis

To Connect RF Cables for Each Module

Complete the appropriate procedure below to connect RF cables for the module.
Note: These procedures assume that the chassis is mounted in a rack.
Standard Prisma II Chassis
1 Attach a 75-ohm RF cable to the appropriate RF source.
2 At the front/rear of the chassis, locate the RF ports.
Note: RF ports are located on the front of the front access chassis.
Attach the other end of the RF cable to Port A connector (RF IN) of the
3
corresponding slot where the module is to be installed. This is the RF input
connection.
If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
4
cables to the connectors at the chassis.
78-4019959-01 Rev D

Connecting the RF Cables to the Chassis

19