Installing The Module In The Chassis; To Install The Transmitter Modules In The Host Module - Cisco Prisma II 1550 nm Installation And Operation Manual

High density qam and superqam transmitter

Table of Contents

Installing the Module in the Chassis

Note:

All Prisma II high-density application modules must be installed in a host



module before they can be mounted in a standard Prisma II Chassis.

Prisma II host modules prior to Rev C (date codes through A2006) do not



support the Controller Area Network (CAN) bus.

To support CAN bus redundancy, the ICIM2 must be Rev B or later.



Complete the following steps to install the application modules in the host module.

Align the ridges on the top and bottom of the module with the guide slots

located on the host module and the chassis. Be careful to keep the module level

as you slide it into the host to avoid bending the pins on the host back plane.

Gently slide the module into the host module until you feel the power and

communications connections on the back of the module join connectors on the

host module. Use the thumbscrew on the top of the module to lock it in place.

Host Module Empty

78-4019959-01 Rev D

Host Module Populated

Table of Contents