Table of Contents
Advertisement
ICIM Introduction
Laser Warning
WARNING:
Do not apply power to this equipment if the fiber is unmated or unterminated.
Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light emitted from an unterminated fiber.
Do not view an activated fiber with optical instruments such as eye loupes,
magnifiers, or microscopes.
Use safety-approved optical fiber cable to maintain compliance with applicable
laser safety requirements.
Even if the unit is off, there may still be hazardous optical levels present.
ICIM Function
The ICIM functions as the module-user interface as well as the interface between the
Prisma II modules and the Transmission Networks Control Systems (TNCS).
The ICIM allows local module configuration and status monitoring for up to 140
modules located in multiple chassis. The ICIM features easy-to-use software that can
be navigated locally on models equipped with a front-panel keypad and LCD
display.
The ICIM can also be navigated remotely using CLI commands or the ICIM Web
Interface. For additional information, see the Prisma II Platform Remote User Interface
Guide, System Release 2.03, part number 4025477.
Important:
Do not operate any Prisma II Chassis without a fan tray installed properly. If a
fan tray is not installed in the Prisma II Chassis, the ICIM will not communicate
with any of the modules in that chassis.
78-4019959-01 Rev D
Avoid personal injury! Use of controls, adjustments, or procedures other
than those specified herein may result in hazardous radiation exposure.
Avoid personal injury! The laser light source on this equipment (if a
transmitter) or the fiber cables connected to this equipment emit invisible
laser radiation. Avoid direct exposure to the laser light source.
Avoid personal injury! Viewing the laser output (if a transmitter) or fiber
cable with optical instruments (such as eye loupes, magnifiers, or
microscopes) may pose an eye hazard.
ICIM Introduction
39
Advertisement
Table of Contents
Troubleshooting
