To Prepare To Change Parameters - Cisco Prisma II 1550 nm Installation And Operation Manual

During a flash operation, the low-level parameters can be changed, including
community strings, port number for traps, IP address, etc.
The procedures below initially tell the ICIM that it is to be updated (flashed),
whereupon it presents a configuration dialog. After new values are entered and
saved, the ICIM is told to not update the program and proceed to normal ICIM
operations.

To Prepare to Change Parameters

1 When the ICIM is powered up, it presents a summary screen along with a
prompt to "...press any key within 5 seconds." The following information
appears:
Start-Up Configuration Dialog
Copyright (c) 2000 - 2004, Cisco Systems, Inc.
------------------------------------------------------------
START-UP MODE:
Run ICIM Application
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.133.194.219
LAN interface's subnet mask is 0xffffff00
SNMPv1 COMMUNITY:
Read Community: public
Trap Community: SNMP_trap
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
Board's Serial Number is ^AAIIJHC
HARDWARE PARAMETERS:
ICIM BSP Revision: ICIM Boot Rom, Rev: BT 0204 (02-23-2004)
MPC860 (Rev 0.2) CPU running at 49 Mhz with 5 Mhz input clock
ICIM Board with 16 Mbytes DRAM and 4 Mbytes App FLASH and 2 Mbytes Boot
FLASH
This board's Ethernet hardware address is 0:2:DE:1:2:3
BOOT ROM PARAMETERS:
IP address of the TFTP host is 192.133.194.4
The file to download and start is ram.crc
After board is reset, start-up code will wait 5 seconds
------------------------------------------------------------
To change any of this, press any key within 5 seconds.
Note: During the first couple of seconds, the ICIM does not respond to a key
press.
2 Press any key repeatedly until the following prompt appears.
(M)odify any of this or (C)continue? [M]
Press Enter to get the default value for Modify.
3
For each of the following questions, you can press < Return > to
select the value shown in braces, or you can enter a new value.
How should the board boot?
1. pROBE+ (for debugging)
2. TFTP
3. Run ICIM Application
Which one do you want? [3] 2
Select 2 for TFTP.
4
Note: We will not be doing a code download, but this gets access to the rest of the
parameters dialog.
78-4019959-01 Rev D
(for code download)
Boot Dialog for ICIM/SNMP Configuration
Write Community: private
Trap Port: 162
69